bryan Posted November 16, 2008 Report Share Posted November 16, 2008 1 ramp set (like used to load garden tractor on truck) 2 pieces of 2x? 1 sheet of 5/8 plywood 2 short nails Attach 2x? pieces in slide area on bottom of ramps. Lower tail gate. Drill one (1) nail hole through each properly spaced out ramp flap and into the tailgate. Put nails in holes to hold ramps in place. Cut plywood to fit length of ramps. Lay plywood on ramps and roll KK onto the truck. DIY SKID for KK cut plywood from above 3 2x4's to fit plywood (2=length, 1=width) screws to anchor 2x's to plywood 2 large screw type eyehooks rope/cable/come-a-long Screw the long 2x4's length wise on bottom of plywood so as not to interfere with ramp use. Screw short 2x4 on top front edge across width of plywood Screw eyehooks close to ends of short 2x4 Load KK Attach rope etc through eyes and pull KK to location (lawn tractor works) Hope this helps and is posted in correct place Quote Link to comment Share on other sites More sharing options...
