Greg_R Posted November 14, 2006 Report Posted November 14, 2006 OK, how has everyone opened the plug for the guru port? Dennis, what is the recommended procedure?
Fetzervalve Posted November 14, 2006 Report Posted November 14, 2006 Re: Breaking the plug open for the Guru port OK' date=' how has everyone opened the plug for the guru port? Dennis, what is the recommended procedure?[/quote'] Hammered from outside in with screwdriver in the center (as recommended by Dennis)
ThreeDJ16 Posted November 15, 2006 Report Posted November 15, 2006 Sorry Greg, I meant to find that thread for you earlier and got tied up. But it looks like Fetz here has honed in on it already for you - cool! -=Jasen=-
rorkin Posted November 15, 2006 Report Posted November 15, 2006 I did the same.. worked fine.. More like chipped out
DennisLinkletter Posted November 17, 2006 Report Posted November 17, 2006 Lost in translation.. Somewhere along the line, a worker changed, transfered but the plug intent was lost here in the factory and the plug became too dense.. They are back to crumpling up a lil ball of paper then making a little refractory ball and plugging the Guru port.. This should facilitate easy removal in the future cookers... Sorry to have made you work to remove them..
DennisLinkletter Posted April 13, 2009 Report Posted April 13, 2009 Install Guru Inducer Tube.. This is the small inducer tube.. The Guru faceplate was designed for it. The hole was CNC (digitally) cut for this tube. When held up to the hole it will appear to be too large for the hole. But with a firm tap.. it will slip in. Sometimes one side will be higher and need to be tapped down. Once in, it is very solid, tight and does not need any silicon.
